The coolingtowers from Vestas aircoil are all made in acid-prooved materials or in galvanised steel, and fiberglass reinforced materials for top/bottom and panels.
All towers are produceed in different versions, depending the specific situation. HB is a high bottom pan, WB is without bottom pan (Dummy bottom with small legs).

OCT04 is a quadratic cooling tower (1950x1950).
It is very flexible when combined in combination with other cells (Placement of air-intake section).
To gain access to replacement of spareparts inside the towers, they are made in two versions; with servicedoor or with an inspection hatch.
These are typicaly placed on the opposite side of the inlet.

 OCT04 SPECIFICATIONS

OCT05 is a rectangular cooling tower (2550x1950).
To compensate the missing air-intake area, when combining cells, the towers will be produced up to three heights.
Air-intake section: 1000, 1500 and 2000 mm, all depending upon the combination of cells.
In all towers the In-and outlet can be placed so it matches the specific situation at site.

 OCT05 SPECIFICATIONS
 

OCT06 is a quadratic cooling tower(2550x2550).
It is very flexible when combined in combination with other cells (Placement of air-intake section).
To prevent the system to be polluted with dust or leafes, the cooling towers can easily be constructed with an easylock-filter, placed over the air-intake section in both sides.

 OCT06 SPECIFICATIONS
 

OCT09 is a rectangular cooling tower (3750x2550).
It is the biggest tower in this cooling tower serie. As admittance to the cooling section for service and maintance, a caged ladder and
servicebridge along the side of the tower, can be placed.
This construction is also available for cooling towers with silencer.

 OCT09 SPECIFICATIONS